Bounty Hunter PROQD Owner's Manual download pdf (Page 13)

Press-and-hold to activate the Pinpoint feature.

Searchcoil motion is not required; a motionless searchcoil over a metal target

will induce sound.

Audio is V.C.O. The 2-digit number displayed indicates target depth, in inches.

The scale in calibrated to coin-sized objects.

How to Pinpoint

After you have identified a target, press-and-hold to identify the target's

exact location. This technique can yield more information about the target's

shape and size and also find its exact location to facilitate extraction.

Pinpoint as follows:

1. Press and hold

2. Position the searchcoil just barely off the ground, and to the side of the

target.

3. Now move the searchcoil slowly across the target, and you can locate it

by the sound.

The target is located directly under where the sound is loudest.

Narrow It Down:

1. To narrow the response further, position the center of the searchcoil near

the center of the response pattern, but not directly over the center.

2. Release .

PINPOINT

3. Immediately press-and-hold again.

4. Repeat this narrowing procedure to narrow the field of detection further.

Note: Depth indication is less accurate after narrowing.

COIL DRIFT

If you plan to use PINPOINT for continuous searching, realize that drift will

occur over time, causing the detector to gain or lose sensitivity. Periodic

retuning of the detector is required to minimize drift; release and press

periodically to retune.

Pinpointing using motion modes (without ):

1. Sweep over target in narrowing side-to-side patterns.

2. Take note of the spot on the ground where “beep” occurs.

3. Step 90° to the side of the target.

4. Sweep searchcoil over.

5. This pinpoints the target location with an “X”.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Bounty Hunter PROQD Owner's Manual Page 13