Bounty Hunter QSIGWP Owner's Manual download pdf (Page 18)

TROUBLESHOOTING GUIDE

SYMPTOM CAUSE SOLUTION

Detector chatters • Using detector • Use detector

or beeps erratically indoors outdoors only

• Using detector near • Move away

power lines

from power lines

• Using 2 detectors in • Keep 2 detectors

close proximity at least 30’ apart

• Highly oxidized • Only dig up

buried object

repeatable signals

• Environmental •

Reduce sensitivity

electromagnetic until erratic

interference signals cease

Constant low tone •

Discharged batteries

• Replace batteries

constant repeating

• Wrong type of • Use only 9V

tones

batteries alkaline batteries

LCD does not lock • Multiple targets •

Move coil slowly

on to one Target-ID present at different angles

or detector emits •

Highly oxidized target

multiple tones • Sensitivity set • Reduce sensitivity

too high

No power, no • Dead battery • Replace batteries

sounds • Cord not connected •

Check connections

securely

• Not moving •

Sweep searchcoil

searchcoil from side-to-side

TROUBLESHOOTING

Note: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Consult the dealer or an experienced radio/TV technician for help.

The manufacturer declares that the minimum ESD performance criteria is 1) the unit shall not

be permanently damaged and 2) operator intervention is allowed.

This product meets the requirements of Industry Canada: CAN ICES-3 B/NMB-3 B.

1 2 ... 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Bounty Hunter QSIGWP Owner's Manual Page 18

Comments to this Manuals