Bounty Hunter Quick Draw Pro Owner's Manual download pdf (Page 18)

TROUBLESHOOTING GUIDE

SYMPTOM CAUSE SOLUTION

Detector chatters, • Using detector • Use detector

beeps erratically indoors outdoors only

or has low • Using detector near • Move away

sensitivity power lines

from power lines

• Using 2 detectors in • Keep 2 detectors

close proximity at least 6 meters

(20’) apart

• Environmental • Reduce sensitivity

electromagnetic until erratic

interference signals cease

Low speaker •

Discharged battery

• Replace battery

volume

• Wrong type of • Use alkaline

battery batteries

Display does not lock

• Multiple targets •

Sweep coil at

on to one Target-ID present different angles

or detector emits • Highly mineralized • Move to a

multiple tones soil different area

• Sensitivity set

too high • Reduce sensitivity

No power, no sounds

• Dead battery • Replace batteries

• Cable not connected •

Check connections

securely

Do not mix old and new batteries. Use alkaline batteries.

Do not mix alkaline, standard (zinc-carbon), or

rechargeable (NiCad, NiMH, etc.) batteries.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Consult the dealer or an experienced radio/TV technician for help.

The manufacturer declares that the minimum ESD performance criteria is 1) the unit shall not

be permanently damaged and 2) operator intervention is allowed.

This product is RoHS compliant.

This product meets the requirements of Industry Canada: CAN ICES-3 B/NMB-3 B.

1 2 ... 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Bounty Hunter Quick Draw Pro Owner's Manual Page 18

Comments to this Manuals

Related products and manuals for Measuring, testing & control Bounty Hunter Quick Draw Pro